750-type floor decking machine

750-type floor decking machine

• Number of forming rows: Generally 20 rows.
• Shaft diameter: The shaft is made of 45# steel. After processing of the solid shaft, its size is usually 90 millimeters.
• Roller material: Processed from 45# steel and hard chromium plated on the surface to enhance wear resistance and service life.
• Feed width: Approximately 1000 millimeters.
• Forming area: The effective width after forming is 750 millimeters, the unfolded width is 1000 millimeters, and the utilization rate is about 75%.

• Machine body structure: The machine body is welded with 300 – 350 millimeters of H-shaped steel, and the middle plate is welded with 16 – 20 millimeters of steel plate to ensure the stability and strength of the machine.
• Middle plate connection: The middle plate connection adopts cast steel pull plates to ensure that the machine does not deform when pressing thick plates.

• Transmission mode: Adopt chain wheel and chain transmission mode. The chain size is 2 inches.
• Reducer: Equipped with 8# double 11 kilowatt planetary cycloidal reducer to make the machine run smoothly and without noise.

• Hydraulic system: The hydraulic system uses gear pumps such as CDF – 10. The motor power is generally 4 kilowatts. It runs smoothly, without noise and has a long service life.
• Shearing method: The shearing adopts thickened middle plate welding to ensure the accuracy and stability of shearing.

• Control mode: The computer control system adopts a highly intelligent industrial electronic programmer PLC and frequency converter control system. The operation is simple, the accuracy is accurate, and the length accuracy is less than 2 millimeters.
• Production speed: The panel output speed is usually 12 – 15 meters per minute.

• Equipment size: 750-type floor decking machine length is about 13 meters, the width is 1.6 meters, and the height is about 1.5 meters.
• Equipment weight: Approximately 10 tons.